Dodge Charger 2005-2010 H.O. System Installation
39
Finishing
PCV System
1
Rotate the PCV bung located on the
driver’s side of the intake manifold toward
the air inlet installed in the previous step.
2
Slide the supplied 1/2” rubber hose onto
the bung, route the line to the underside
of the inlet and connect it to the plastic
barb fitting. The hose may need to be
trimmed for proper positioning.
Finishing Up
1
Mount the front bumper cladding back
onto the front bumper. Snap it into place.
2
Mount the front fascia back onto the
vehicle. Connect the wiring harness on
the passenger’s side of the vehicle that
is attached to the fascia. Tighten all
hardware.
3
Replace the factory underside cladding
using the factory hardware for undercar
connections. Use the supplied push pins
for the fender well connections where the
factory pop rivets were drilled out.
4
Place the radiator cavity covers in position
and snap them into place.
5
Reconnect the battery.
PCV Bung Rotated
PCV Installed
a...,29,30,31,32,33,34,35,36,37,38 40,41,42,43,44,45,46,47,48