26
Dodge Charger 2005-2010 H.O. System Installation
Vacuum Manifold
V
acuum
M
anifold
1
Assemble the supplied vacuum manifold
as shown. If you have or are installing a
boost gage, do not install the plug, use an
additional barb fitting. Thread each fitting
into the manifold. Thread the 3/8” barbed
fittings onto each end of the manifold.
Tech Tip:
The boost switch is used for
full system 6.1L SRT8 models only. If you
are installing this kit onto a 5.7L model,
plug this port.
2
Locate the brake booster hose on the
driver’s side near the firewall. Remove
a 3-1/2” section of this hose in order to
place the manifold in-line.
3
Mount the manifold by sliding each barbed
fitting into the open ends of the brake
booster hose. Secure the connections with
the provided #06 hose clamps.
4
Be sure the brake booster hose
connections are tight; verify the
connection to the booster did not come
loose as well.
Vaccum Manifold Assembly
Manifold
Boost Switch
Line to Surge Valve
Plug
Vacuum Manifold Installed
a...,16,17,18,19,20,21,22,23,24,25 27,28,29,30,31,32,33,34,35,36,...48