Dodge Charger 2005-2010 H.O. System Installation
Crank Pulley Pinning
Remove the pinning tool and set aside.
Clean the chips from inside the drilled hole
and the surrounding area throroughly.
Install the supplied 1/4” OD x .75” long
stainless steel dowel pin in the hole. Re-
install the crank pulley bolt and tighten to
129 ft-lbs.
Replace the fan assembly into the vehicle.
Tighten the (2) 10mm bolts to secure the
assembly; reconnect the wiring harness to
the fan.
Crank Pulley Pinned to Crankshaft
Drilling the Crank
Drill Jig Installed
a...,i,ii,1,2,3,4,5,6,7,8 10,11,12,13,14,15,16,17,18,19,...48